Directions
1. Take one end of your Buddy Braids wire and thread 1 crimp tube approximately an inch from the end. Thread the bar end of your toggle clasp. Thread the end back through the crimp bead. Using a pair of pliers squeeze the crimp tube about a 1/8th of an inch away from the clasp. See illustration 1. Trim the excess leaving about a quarter of an inch, you will thread the first bead over both ends.
Illustration 1
2. Thread the following:
1 - 8mm Teal Glass Pearl, 1 - 8mm Copper Bead Cap, 1 - 4mm Champagne Crystal Round, 1 - 6mm Peach Glass Pearl, 1 - 6mm Gold Crystal Bicone, 1 - 6x2mm Copper Beaded Rondelle, 1 - 10mm Red Orange Sardonyx Semiprecious Round, 1 - 6x2mm Copper Beaded Rondelle, 1 - 6mm Gold Crystal Bicone, 1 - 6mm Peach Glass Pearl, 1 - 4 mm Champagne Crystal Round, 1 - 8mm Copper Bead Cap, 1 - 8mm Teal Glass Pearl, 1 - 8mm Copper Bead Cap, 1 - 4mm Champagne Crystal Round, 1 - 6mm Peach Glass Pearl, 1 - 6mm Gold Crystal Bicone, 1 - 6x2mm Copper Beaded Rondelle, 1 - 10mm Red Orange Sardonyx Semiprecious Round, 1 - 6x2mm Copper Beaded Rondelle, 1 - 6mm Gold Crystal Bicone, 1 - 6mm Peach Glass Pearl, 1 - 4mm Champagne Crystal Round, 1 - 8mm Copper Bead Cap, 1 - 8mm Teal Glass Pearl, 1 - 8mm Copper Bead Cap, 1 - 4mm Champagne Crystal Round, 1 - 6mm Peach Glass Pearl, 1 - 6mm Gold Crystal Bicone, 1 - 6x2mm Copper Beaded Rondelle, 1 - 10mm Red Orange Sardonyx Semiprecious Round, 1- 6x2mm Copper Beaded Rondelle, 1 - 6mm Gold Crystal Bicone, 1 - 6mm Peach Glass Pearl, 1 - 4mm Champagne Crystal Round, 1 - 8mm Copper Bead Cap, and 1 - 8mm Teal Glass Pearl.
3. Thread 1 crimp tube and the round part of your toggle clasp. Thread the wire back through the crimp bead after going through the loop on the toggle clasp. Thread the wire through several beads (see illustration 2). Using your pliers, squeeze the crimp tube about an 1/8th of an inch away from the clasp. Trim the excess wire as close to the bead as you can.
Illustration 2
You’re done!! These directions make a bracelet that is approximately 8 inches long. If you need to change the length just add or subtract beads. You can use this pattern with any color beads you wish!!
