Joyous Wanderings Anklet

Step 1 - Create Teardrop Drops

Your drop will look like this when you complete the following steps! Make a total

of 5 drops for this anklet.

Take one of the head pins and add a 4mm Fluorite round. Just above the stone begin

the loop directions above. You will only be able to wrap the wire one or two times.

Open the eye of one of your eye pins, add the Fluorite round drop you just made, and

close the eye of the eye pin.

Add a 13x9mm Crystal teardrop and a Flower Bead Cap. Just above the bead cap begin

the loop directions above. You will only be able to wrap the wire one or two times.

Repeat 4 times!!

Now you’re ready to make your anklet!

Step 2 - Create Anklet

1. Take one end of your Buddy Braids wire and thread 1 crimp bead approximately an

inch from the end. Thread a 5mm Jump Ring. Thread the end back through the crimp

bead. Using crimping pliers (or any pliers you have) squeeze the crimp bead as close

to the jump ring as you can. See illustration 1. Trim the excess leaving about a half

an inch, you will thread the beads over both.

Illustration 1

2. Thread the following:

1 - Goldstone Round, 1 - Aventurine Round, 1 - Goldstone Round, 1 - Purple Cat’s

Eye Bead, 1- Glass Pearl, 1 - Teardrop drop, 1 - Glass Pearl, 1 - Purple

Cat’s Eye Bead, 1 - Goldstone Round, 1 - Aventurine Round, 1 - Goldstone Round,

1 - Purple Cat’s Eye Bead, 1- Glass Pearl, 1 - Teardrop drop, 1 - Freshwater

Pearl, 1 - Purple Cat’s Eye Bead, 1 - Goldstone Round, 1 - Aventurine Round,

1 - Goldstone Round, 1 - Purple Cat’s Eye Bead, 1- Glass Pearl, 1 - Teardrop

drop, 1 - Glass Pearl, 1 - Purple Cat’s Eye Bead, 1 - Goldstone Round,

1 - Aventurine Round, 1 - Goldstone Round, 1 - Purple Cat’s Eye Bead,

1- Glass Pearl, 1 - Teardrop drop, 1 - Glass Pearl, 1 - Purple Cat’s Eye

Bead, 1 - Goldstone Round, 1 - Aventurine Round, 1 - Goldstone Round, 1 - Purple

Cat’s Eye Bead, 1- Glass Pearl, 1 - Teardrop drop, 1 - Freshwater Pearl,

1 - Purple Cat’s Eye Bead, 1 - Goldstone Round, 1 - Aventurine Round,

1 - Goldstone Round

3. Thread 1 crimp bead and the other Jump Ring. Thread the wire back through the

crimp bead after going through the Jump Ring. Thread the wire through several beads.

Using your pliers, squeeze the crimp bead as close to the jump ring as you can. Trim

the excess wire as close to the bead as you can.

You’re done!! These directions make an anklet that is approximately 9 inches long. If you need to change the length just add or subtract beads. You can use this pattern with any color beads you wish!!